Micca mplay Owner's Manual download pdf (Page 10)

VI. Connecting the Micca MPLAY

A. Power

Only use the supplied AC power adapter to provide 5.0VDC power to the Micca MPLAY. Using

a different power adapter may damage the player. Do not cut off power to the device while the

unit is turned on as this may cause serious damage to attached storage devices and result in

data loss.

The MPLAY has a master power switch on the back. During normal use, set this switch to on

and use the remote to turn the MPLAY on or put it into standby mode. Set this switch to off if not

planning to use the MPLAY for a long time to conserve power. Make sure that the player is in

standby mode before disconnecting power.

B. AV Output

The Micca MPLAY can be connected to analog TVs through its AV Out connector. Only use the

supplied 3.5mm-to-RCA AV cable to ensure correct signal polarity and avoid damage to the

player and TV/display.

The RCA cable connectors are color coded to match the AV input on TVs and display devices

as follows:

Red

Right Audio Channel

White

Left Audio Channel

Yellow

Composite Video

The Micca MPLAY must be set to NTSC or PAL Composite mode for the analog AV output to

function. If there is no picture displayed after connecting the AV Output and turning on the

Micca MPLAY, press the <Setup> button on the remote and then press the <TV Mode> button

to switch between output modes until the correct mode has been selected. There will be a short

delay when switching output modes so please wait a few seconds between presses of the <TV

Mode> button.

C. Component Video Output

The Micca MPLAY can be connected to HDTVs through its YPrPb (Component) video

connector. The Micca MPLAY’s component video output resolution is fixed at 1280x720p. The

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

No comments

Micca mplay Owner's Manual Page 10